Here is the Taylor Battery box Contents. You will need a few items that were not included depending on how you hook up your old wiring to the new cabling. I wanted a nice clean look so i purchased some additional ends, cable covering. |
|
|
|
Ready Rod & Cables |
The Aluminum Battery Box |
Here is the target location (before) |
|
|
|
Original Battery (up front of car) |
Another View of the battery. |
Battery Removed from its home |
|
|
|
Putting the new battery box in trunk |
I Wanted it right over the rear axle |
Marking holes with paper template |
|
|
|
Holes drilled and in trunk |
Bottom rod coming out of trunk |
Mounted (- cable to frame) |
|
|
|
Battery Box Installed |
Here is the rear seat release (just press forward) |
Another view of button to release rear seat in your mustang. |
|
|
|
Some Strange Angle :>) |
Positive battery cable arriving at its destination |
Painted fender before ignition relocation |
|
|
|
| Relocating the battery was very simple to do. The one part that i wish i had seen before was the firewall route for the battery cable. There is a large grommet that you are able to drill a hole through then route the battery cable up and around the brake booster. Once i found that it was a snap. Oh and that dam rear seat release. Very simple button to press (IF YOU KNOW ITS THERE) :>) EHE. |
