Baur Bump Steer Kit Install!
Just completed the Baur Bump Steer Kit i purchased from MustangNick on The Corral. It was a great deal i couldn't pass up.
| Baur Bump Steet Kit |
|
|
| A great deal from an online forum purchase |
Close up of a BumpSteer (tie rod end) |
|
|
| Sperical Bushing with spacers below to adjust the angle |
Stock Tie Rod end mounted to spindle on an SN95 Mustang |
|
|
| Side By Side of Tie Rod End vs The Bump Steer Kit |
Seating the Bump Steer End onto the Steering Arm and Spindle |
|
|
| Finished End After Adjusting with a floor jack to see how level the 2 were |
Looking Up from the ground at the bump steer kit installed to see if its level. Digital cameras are very handy |
|
Another angle of the kit installed on my mustang. I sure need a K Member and A-Arms. (Maybe next winter) |
The Installation was very simple. Removal of the old tie rod ends was easy. Here is an article by Steeda regarding the install of their bumpsteer kit. It will definatly help you to understand what bumpsteer is and how lowing your mustang can "enhance the condition" View the Steed Bump Steer Kit Install
I wont be doing my allignemnt until all suspension front and rear are installed. Ride height will be established then with the new tires. Then off to the allignement shop i go.
I am not sure who in Edmonton has experience with bumpsteer but i will let you know how my alligment turns out. |