The Supercharged Mustang News and Updates
Whats been happening in the last few months as i drain my bank account on upgrading my mustang!

May 2005

• Purchase used 1994 SN95 Mustang
• Leanne and worked for 10 hours to replace the headers LOL good learning experience. Completion of Exaust with the removal of the Cats and Installation of the Flowmaster Mufflers.

June 2005

• Trick Flow High Port Cylinder Heads
• Trick Flow Track Heat Intake
• Ford Racing Stud Mount Roller Rockers
• Professional Products 75MM Throttle Body

July 2005

• Purhcase 42 LB Injectors
• Powerdyne Supercharger
• Purhcase Pro M MAF
• Trick Flow Gasket Set with Orings
• Install 75MM Throttle Body

August

• Ordered in a DSS Pro 331 Stroker Level 20 Short Block
• Decided on a Spec Stage 3 Clutch and Spec Alluminum Flywheel
• August 11th Paid Duty's etc on Engine and its arrived in Edmonton!
• August 11th Tow Truck arrived and hauled the car off to AFI Performance for the engine swap and parts install. After they complete the work its Dyno Tune and Chip Time.
• Clutch and Flywheel should arrive on Monday or Tuesday
• Cobra 500 wmv

September

• Drive the car as of now and enjoy the raw power of that stroker motor. It sure sounds nice at 3000 rpm.

December 2005 / Jan 2006

Saved Up and Purchased Some Rims and Tires! (January) One of the more expensive upgrades!

February 2006

• Purchased a Modular Mustang Racing Coil Over Package, along with 5 way adjustable struts.
• Installed the Rear Coil Over Kit with Vic.
• Ordered Caster Camber plates when funds permitted! Waiting on arrival to complete the front suspension upgrades.

March

• Install Taylor Battery Box Relocate Kit (6th)
• Relocate Front Electrical and igintion Module.
• Straighten up plumbing on the blower
• replace all plastic wire covers on old battery wiring.
• ordered maximum motorsports panhard bar, rear control arms, ford racing upper control arms, new bushings (axle) bushing tool. Now the rear end of the car should hookup nicely.
• Cleaned and painted rear frame rails and gas tank area.
• I installed a new Autometer oil pressure guage (14th)
• The parts arived from Stang Suspension March 29/30th i jacked up the car and started to clean and prep the bolts with some wd40 befor i went for the Lower Control Arm Installation

April

• Sand And Paint Hood, Replace broken headlamp with new halo projector headlights.
• Comepleted painting the hood, hood pins and grills!

May

Install Projector Headlights!

June

First trip out to the drag strip and the new Castrol Raceway. I did a terrible job driving the car but it was sooo fun. :>). We welcome our newest paid advertiser Affiliate Classroom thank you for the Parts Donation (Tubular Front Control Arms) from Modular Mustang Racing.

Future Plans

• Peplace rearend carrier and install 3.55 gears
• Purchase a Transmission (6 Speed) or a MMR 750 T5